Grouped Renewables Limited

Phone +44 (0)1561 362227  Email info@groupr.co.uk

Olymp HC8S

Olymp HC8S

 

The HC Range has been in production since 1982.

Patented Dynamic Pressure Relief
Single or Twin Pump units
Small Footprint


MULTI FUNCTION

  • Expansion - no membrane vessel
     
  • Automatic pressure maintenance - reduced maintenance costs
     
  • System top up - equalise water loss
     
  • Pressure Step Degassing - protect the system from damage
     
  • Dirt removal - by settlement, additional filter option
     
  • System Dosing

 

Download Brochure here

No membrane pressure vessel.

The expansion is at  atmospheric pressure which not only minimises the expansion vessel size, but also allows the pressure step de-aeration process. 

No membrane in  the vessel means no gas pressure to maintain, no membrane to replace

Download Technical Information here

Free and dissolved gases or air bubbles, formed during system filling and  absorbed from parts of the heating system are removed using this unique  de-aeration device.

Opening a mineral water bottle produces gases which  were dissolved in the water, the Olymp Automat uses the very same  principal to remove from the installation all aggressive and destructive gases even from remote areas of the system.  See Henry's and Dalton’s Laws -   adiabatic gas separation.

Line

Small System Pressurisation Units

HC7ND.

System pressurisation and top up

Models
HC7N - Single Pump
HC7ND - Twin Pump

Specification
Digital controller
Pump  4 Bar
Connection 1/2”
3 Volt free connections
Alarms - High pressure, low pressure, general fault

Pumps
230 Volt
400 VAC (per pump)
Regular pump kick start for continuous operation
HC7ND auotmatic pump changeover  on each activation

Tank
25 litre  Nominal
Polypropylene 
Chemically inert to chemicals normally used in heating/cooling systems
Cold and heat resistant


Dimensions
560mm Long x 650mm high x 300mm deep
Weight
(HC7N empty) 22Kg
(HC7ND empty) 25Kg
 
Line
WM2E Pressurisation unit
WM2E Pressurisation Unit Internals
WM1E  Pressurisation unit Internals

WM1E Single Pump Digital Unit

WM2E Dual Pump Digital Unit

  • Cold Fill upto 3 Bar
  • Cold Fill Factory Set at 1.5 Bar
  • 9 Litre type “A” break tank
  • Pressure Transducer 0 - 10 Bar 4-20mA Current Loop
  • Volt free alarm contact
  • Digital Controller
  • Finished in RAL 7032
  • Floor mounting chassis option
  • High Pressure pumps options
  • High/Low pressure Switch Option
  • Expansion Vessels also Available

Analogue Units also available

WM1E Detail
WM2E Detail
Line

Expansion Vessels

Expansion Vessels
Expansion Vessel
  • Various Expansion Vessels
  • Up to 5 year warranty
  • Gas charge to your specification available (certain models)
  • Potable
  • Non Potable
  • Domestic
  • Commercial
[Products] [Wood and Pellet  Biomass] [Pellet or Chip Biomass] [Gas Boilers] [Gas Fired Water Heaters] [Solar Thermal] [One4All Heat Centre] [Low Energy Radiators] [Storage Vessels] [Air & Dirt Removal] [Pressurisation Units] [Booster Sets] [Ancillaries] [Bellows, S/S Pump Connectors, Hoses] [Expansion Joints &  Anchors]